8/27/2023 0 Comments Voopoo drag xGone are the days where you need to take the Pod off of the device to fill, the new TPP X Pod has a lockable rotating ring around the top that you can spin around to reveal the ‘top/side’ fill port. The most noticeable change on this Pod however, is the new way of filling. The capacity of the TPP X Pod has increased, you can now fit 5.5mls of e-liquid in there, where you could only get 4.5mls into the older PnP pods. Personally I would have included the o-ring inside the top of the drip tip recess, so that vapers could use even more custom drip tips, but I’m assuming they have their reasons for doing it like this. While the 810 removeable drip tip is awesome, and you can use your own on there, you are limited to using drip tips with external o-rings unfortunately. This new Pod features, a removable 810 drip tip, a hidden side fill, larger capacity, and slightly different base. The new TPP X Pod, is made from clear PCTG plastic and stainless steel, whereas the older PnP Pods were entirely tinted PCTG. When I say they’ve been redesigned from the ground up, I mean it. Don’t worry if you love the original PnP Pods though, you can also use them on the Drag X Pro too. In short it’s basically a Pod that will enable you to run TPP coils on all of your Voopoo Pod Mod products. Voopoo have been careful to make sure this new Pod is compatible with not only all of their older devices that take the PnP Pods, but their new TPP coils. It’s been redesigned from the ground up keeping user’s feedback in mind. Here’s something new, Voopoo’s new TPP X Pod. The Drag X Pro, also now takes a 21700 battery, or an 18650 battery with a sleeve, compared to the original which only took 18650 batteries. It’s much softer, and stops scratches on the bottom! It feels so nice putting the device down on the table now. That’s right! No more x5 clicks of the fire button to turn off/on!!Īnother notable feature, and it really is a small thing but makes all the difference, is the silicone or rubber strip on the base. Not only does this switch allow you to lock the device physically, but it can also be set in the device itself, to operate as a Power On/Off switch too. The front face is identical to the original, with the exception of this small switch between the adjustment buttons and the USB charging port. Probably the most notable change here however, is the switch on the front face of the device. You’ll notice from the photos above that the Pod connection has changed, it’s now a 2 pin connection instead of 3, the airflow is now a 360 degree adjustable airflow ring, compared with the 180 degree lever that was on the original. ![]() It’s still a zinc-alloy based frame, with a leather heel, the embossing is a little different, but that’s really it for the main casing. There are some subtle differences and some not so subtle differences to the new model. The Drag X Pro is an external battery (18650/21700) capable Pod Mod, with a maximum wattage of 100 Watts, a 5.5ml e-liquid capacity, 360 degree adjustable airflow, with both button and auto-draw modes, all using Voopoo’s new TPP coils which pump out some amazing flavour and vapour. Let’s run through what the Drag X Pro actually is before going on about the improvements. ![]() There are a few, both aesthetic, physical as well as functional. ![]() Well, in it I explain all of the updates that Voopoo have made to these latest Drag S/Drag X Pro devices. You’ve all read my Drag S Pro review right.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |